Tag Archives: Brad (Chuck It Junk Removal)

2015/07/20 (M) Chuck It

Our morning got busy right away.  We had breakfast and I made coffee while Linda entertained Madeline.  Brad, from Chuck It Junk Removal, dropped off the dumpster trailer at 9 AM.  Keith, from Kish Lawn Care, showed up at 9:30 to cut the grass.  Linda took Madeline to the Mill Pond to use the playscape and Mara started scrapping old caulk and putty from around the base of her refrigerator roof vent.  I tried using another set of tools for removing the stripped screw in the stop block on the bus to no avail.  I even managed to break off two drill bits in the hole I was drilling in the screw.  The more I work on this the worse it gets.

When Linda and Madeline got back Madeline had lunch and then laid down for her nap.  The three adults then had vegan hotdogs for lunch after which I put the finishing touches on my design drawings for the pull-out pantry.  Mara and I then went on an errand run.

Our first stop was the FedEx store in Novi where I made copies of all of the drawings for the desk and the pullout pantry.  We then stopped at General RV to return the refrigerator vent cover as it did not fit the base section on Mara’s roof.  They had a Camco cover that claimed it would work, and looked like it might fit, so she exchanged them and got a small credit.  When we got back at 3:15 PM Brendan and Shawna were already there.  They got Madeline up at 3:20 PM and stayed until about 4 PM.  After they left I got up on Mara’s roof to help with tasks there.

First we checked the refrigerator vent cover.  The mounting holes lined up but the flanges (shields) on the long sides were not wide enough to fit outside the base flanges.  The proper fit requires the upper flanges to be outside the lower flanges by at least 1/4″ so heat can escape and extend below the lower flanges to keep rain from getting into the refrigerator cavity.  I was going to install the 24″ x 24″ piece of thin sheet steel for the magnetic cell phone booster antenna when I discovered that the antenna would stick to the old satellite dish.  We experimented some more with the location of the inside antenna but could not improve on yesterday’s placement.  The performance was as good as with the metal sheet so I decided not to install the metal sheet.  Mara then caulked around the refrigerator vent base and touched up a few other spots around tank vent caps.

Linda grilled a variety of veggies for dinner.  I opened a bottle of Pinot Noir wine and we ate outside.  It was cloudy and 76 degrees F with light winds; very pleasant and bug free.  We had fresh strawberries with the meal and dark chocolate for dessert.  We eventually moved inside to chat but did not stay up late as I needed to be up early in the morning and on my way to Indiana.